Bocephus
Well-Known Member
Sorry, American Adventure LabsAAL? My search is failing me.
Sponsored
Sorry, American Adventure LabsAAL? My search is failing me.
Seems like that might be a bit close for comfort to any passenger, based on the 2-3’ distance mentioned above.Cool Tech HAM/GMRS mount
I like that it blends in with the factory antenna location.
https://www.cooltechllc.com/2018-jeep-wrangler-jl/139-gladiatorwrangler-front-antenna-mount.html
Good lookin out, I calculated based on worst case scenario, maximum wattage, antenna gain, and 50% duty cycle and came out to 12” as a safe radius. I use minimum wattage to maintain communication (usually 5w not 50w) I’m quite comfortable with the exposure levels, especially as the passenger compartment is mostly obscured by the A-pillar.Seems like that might be a bit close for comfort to any passenger, based on the 2-3’ distance mentioned above.
I'm suddenly reminded I really should do something with all that Ham knowledge I crammed into my head long enough to take an exam.Good lookin out, I calculated based on worst case scenario, maximum wattage, antenna gain, and 50% duty cycle and came out to 12” as a safe radius. I use minimum wattage to maintain communication (usually 5w not 50w) I’m quite comfortable with the exposure levels, especially as the passenger compartment is mostly obscured by the A-pillar.
I like that mount! Gets it up an inch higher. Every little bit helps!Cool Tech HAM/GMRS mount
I like that it blends in with the factory antenna location.
https://www.cooltechllc.com/2018-jeep-wrangler-jl/139-gladiatorwrangler-front-antenna-mount.html
That’s why I got the lift tooI like that mount! Gets it up an inch higher. Every little bit helps!
I ended up ordering a custom length from TheAntennaFarm.com; 10 feet.The excess antenna wire, where are you stashing it?
Is that the Midland MXTA26 antenna? I just bought the MXT275 and I'm looking for a decent tailgate antenna mounting solution. I understand the whole ground plane vs NGP situation, just looking for input on your specific solution.Here is my GMRS setup.
Happy New Year!
Larry
That looks like a rocket launcherDesigned and built some mounts:
2m/70cm/GMRS to the left, HF/CB to the right. They’re designed for use with the top off (a fastback top might also be OK), but they’re decent with the hardtop on.
Grounding was a bit of a pain. Ended up snaking one wire down through the tailgate hinge area to the body isolator frame bolt, and another along the top of the body and then down to the ground stud near the rear passenger door.
I have the other four prototypes out for powder coat, then I need to figure out if I want to leave the paw cut-outs as-is, or add a bikini pearl insert..
That looks like a rocket launcher
That looks different than the Cowl antenna mounts I see on their website.Once I upgraded my tailgate to the CavFab carrier, my Krackin mounts for antennas didn't work any more (expected result of the upgrade). So after looking a while and contemplating making something, AAL released their new A Pillar mounts. I had thought it would be a great place for mounting the antenna but with the KC bar, most of the stuff on the market wasnt viable. These bolt right in and work great. Modular so I have the ability to mount antennas on either side and got their pod light mounts. Not sure what I'm going to do longer term with it all but have the Midland 3db antenna hooked up to my new MTX575. Very solid mount, worked great last weekend up at WIndrock TN