Good point, you're right, my terminology is probably not correct. I go tight with the provided tool, which is small enough to just get snug without breaking/stripping anything. I'm not yanking on the end, I'm turning the tool at the center with minimal force.
The important thing is I was pretty sure I knew what you meant, I just had to make a joke out of it though.
Crank the first one down until it breaks, then tighten the rest just shy of that point.
Me too, and I don't remove the top often enough to worry about any easier way to get it done, it's pretty simple as-is, similar to disconnecting my sways, no need to make it easier in my case.
Is that a CV joint for your power screwdriver?
