CDwest7254
Active Member
- Thread starter
- #1
Finally figured out a sleek way to get onboard compressor under passenger seat with no drilling into the Jeep and only using factory holes as install points
Had to fabricate my own bracket, but it turned out great. All I need to do now is anodize or powder coat the bracket.
Key points:
Had to fabricate my own bracket, but it turned out great. All I need to do now is anodize or powder coat the bracket.
Key points:
- I used factory harness hole in firewall to thread the compressor harness through (you do have to make the battery portion of the harness longer)
- I used the 2 rear bolts for the seat attachment to attach my custom bracket. I attached the compressor directly to the bracket. I made the bracket with 1/4 offset so the nuts on the bottom side would set directly on the carpet giving the bracket a perfectly flat install.
- I used the existing trim covers to route the harness up to the firewall
Sponsored