ARB Single compressor mount spot

[Deleted member 84971]

Hey guys, I saw this idea on YouTube, I forgot the channel. But basically you remove the engine beauty cover and that frees a bracket on the passenger side

Check these photos from my Jeep JLU 2021:

Main view:

Clears existing hoses:

Clears oil stick:

Clears the hood, very minimal rubbing agains the internal liner

Has two attachment spots:

Bracket + arb mount view:

So what do you guys think ? YAY or NAY ?

Sponsored

 

[AZJeepGuy]

I like it. Is there a way to trim the cover to make it fit again?

 

[redracer]

Nay! too much heat.

I mounted my ARB single on the drivers side firewall using a Way-a-life mount. Tho, that is also a hot spot, being next to a Cat, so some insulation is required. But, i can fill all 4 35's from 10 to 30 without stopping.

I picked up the ACM Mount and an ARB single. The install is pretty straight forward. My only problem with this spot is that it is near the exhaust cat. So, after installing it once, I went by my local auto parts store and picked up some heat shielding material, unmounted it, pinched the material between the compressor and mount on one side, and zip tied the material to the air reservoir (covering the zip tie with another piece of shielding) to cover and protect the compressor.

 

[GrayWolf.Overland]

Install where you get clean and normal temperature air to the compressor. Rear cargo cubby, or below the passenger seat are great locations. I have mine installed under the passenger seat and airs up my 33s in under 2 minutes from 18psi to 35psi

Sponsored