1996cc
Well-Known Member
- Thread starter
- #1
Advance Adapters FINALLY has the correct parts to make this work (even if they do scab 3 adapters together ). I’ll save all the drama for another day, but the main case and some of the parts have been sitting on my shop floor since mid-December. Today the rest of the pieces showed up, so I left work early and dove right in. Here we go… (This won’t be a full step by step detail, but I will try to cover the points they don’t and any key details I think are important.
Original shipment-
The 392 specific parts that came today- (the instructions have you installing the bearing and spud shaft. My guess is this was their test fit one and they threw it in the box to get it to me ASAP since I’ve been religiously reminding them of my urgency- my current case is acting up)
What instructions they do have tell you to cut the stock transfer case cable to remove it . I found it much simpler to just pop off this ball end joint and remove it intact.
Before removal-
Comparison pics-
Original shipment-
The 392 specific parts that came today- (the instructions have you installing the bearing and spud shaft. My guess is this was their test fit one and they threw it in the box to get it to me ASAP since I’ve been religiously reminding them of my urgency- my current case is acting up)
What instructions they do have tell you to cut the stock transfer case cable to remove it . I found it much simpler to just pop off this ball end joint and remove it intact.
Before removal-
Comparison pics-
Sponsored
Last edited: