TazerJL Feature Requests

[WXman]

I'd like the option of operating the windows with the key fob like what the Ram 1500s are doing.

Sponsored

 

[drdriller]

When key fob leaves the Jeep, have dic state, Elvis has left the building

 

[NCIC105]

When key fob leaves the Jeep, have dic state, Elvis has left the building

Bahahahaha... Or "I'll Be Back"

 

[freddiegs]

Allow TPMS setting to go lower than 25 psi

 

[Rhinebeck01]

Allow TPMS setting to go lower than 25 psi

@freddiegs

Not going to happen. Not doable.

 

[freddiegs]

@freddiegs

Not going to happen. Not doable.

It use to allow you on 11.0.6 I'm guessing it would allow you to but it wouldn't actually change the minimum requirement set point?

 

[Rhinebeck01]

It use to allow you on 11.0.6 I'm guessing it would allow you to but it wouldn't actually change the minimum requirement set point?

@freddiegs

Was problematic. Joe had to remove. So, not gonna happen..

 

[Kidder212]

I just requested turbo saver mode that lets engine idle for 2 minutes to cool the turbo before total shut down

 

[Kevin Mojito]

Not sure if it can be done.
2 Low range, by turning FAD off so it does not engage front axle?

 

[NCIC105]

When key fob leaves the Jeep, have dic state, Elvis has left the building

Bahahahah...Or have it make the sound of a light sabor...

 

[ArmyJeeper]

Can you make the Blind Spot Warning System work without the doors? Maybe a light on dash or Uconnect screen.

 

[wobbie07]

I still think that retrieving CEL codes would be great.

 

[RocketScientist]

Ability to enable autodim mirror

I added correct harness and mirror. Mirror has power and the SOS/assist buttons work (well, can’t get FCA to add Guardian as my “Jeep was not delivered with this option”)

The autodim mirror option does not show up in uconnect. I would think this could be an easy change?

 

[MyJlU]

Awesome ideas

I just requested turbo saver mode that lets engine idle for 2 minutes to cool the turbo before total shut down

I still think that retrieving CEL codes would be great.

 

[danny01]

A toggle for enabling the "Daytime Running Lights" customer programmable feature to show up in the UConnect Lights menu.

This is especially for Sport and Sport S owners who want to activate factory DRLs after switching to the Morimoto Sequential DRL/Turn Signals. Even though you can switch DRL region to US and set location to Dedicated on the Tazer, they still won't work because the BCM also checks for the UConnect DRL setting to be set to ON, which doesn't show up on Sport models from the factory, and is OFF by default.

@joe@zauto

Sponsored