OFF ROAD PAGES - What Version does your JL/JLU currently have?

[Fastmover]

Not driving much due to winter and salt. Checked ORP today, v 17.xxxx. It took a half hour of driving before the software update message appeared. Following the update ORP still v 17.xxxx. I'll have to wait until my next drive in good weather to check the version # again. Here are the screens I saw.

Sponsored

 

[INCRHULK]

Yup, I updated tonight and off-road pages remained at version 17.x

 

[Rhinebeck01]

My UConnect did another OTA update this morning. Update went without issue. ORP still alive and well. Loads so quickly I have not been able to ascertainvversion #.

 

[Gorilla57]

Mine is now V20#####

Didn’t notice the update, but it was V19#### a few weeks back. Nothing has changed that I can tell.....????

 

[Toycrusher]

This is still a sore point for me. Off-road pages has only appeared twice in 3+ years. Each time after an update, and each time for less than five minutes before disappearing

 

[INCRHULK]

This is still a sore point for me. Off-road pages has only appeared twice in 3+ years. Each time after an update, and each time for less than five minutes before disappearing

That's a bring it in for warranty work...

 

[am1978]

My UConnect did another OTA update this morning. Update went without issue. ORP still alive and well. Loads so quickly I have not been able to ascertainvversion #.

Same here. Failed first try, but it tried again and updated successfully. The version is a 20xxxxx. I’ll catch it later unless someone else does. Not sure what they have fixed here, but again a CDD/VDD from uconnect would be nice.

 

[Rhinebeck01]

My UConnect did another OTA update this morning. Update went without issue. ORP still alive and well. Loads so quickly I have not been able to ascertainvversion #.

@jludave
@OldGuyNewJeep

Well, I actually see an improvement thanks to this latest UConnect update.... Where in ORP, I was seeing Altitude, longitude and latitude show as dashes .... going MIA, lots when driving.... now Altitude, longitude and latitude are always there.... never MIA. Also, no occasional unwanted reboots pf UConnect since the last update..

 

[OldGuyNewJeep]

@jludave
@OldGuyNewJeep

Well, I actually see an improvement thanks to this latest UConnect update.... Where in ORP, I was seeing Altitude, longitude and latitude show as dashes .... going MIA, lots when driving.... now Altitude, longitude and latitude are always there.... never MIA. Also, no occasional unwanted reboots pf UConnect since the last update..

Mine just rebooted itself three times in a row on the way home from the supermarket. In between the reboots it was frozen. I could not change the station or adjust the volume.

 

[jludave]

@jludave
@OldGuyNewJeep

Well, I actually see an improvement thanks to this latest UConnect update.... Where in ORP, I was seeing Altitude, longitude and latitude show as dashes .... going MIA, lots when driving.... now Altitude, longitude and latitude are always there.... never MIA. Also, no occasional unwanted reboots pf UConnect since the last update..

I don’t get any updates since my 8.4” radio was not factory installed.

 

[Rhinebeck01]

@jludave
@OldGuyNewJeep

Well, I actually see an improvement thanks to this latest UConnect update.... Where in ORP, I was seeing Altitude, longitude and latitude show as dashes .... going MIA, lots when driving.... now Altitude, longitude and latitude are always there.... never MIA. Also, no occasional unwanted reboots pf UConnect since the last update..

Just bumping my own post...... Since the post above / since that OTA update, I have not seen longitude, latitude and altitude missing one time... whereas they used to be MIA lots...

Also, only one reboot of the radio on it's own. New though... never happened before over the last 3 years, the b/u camera went to black screen. I did an F97 fuse pull and that brought it back...

.

 

[FerrdIsTheWord]

I'm on ORP version 20.xxxx. Seems to load faster than it did before but I'm still missing my altitude and lat/long.

Sponsored