What bumper is that? Looks good!
looks like a ROAM bumperWhat bumper is that? Looks good!
Agreed, that is a nice look!What bumper is that? Looks good!
How you liking this so far? Mine will be here Wednesday.Quadratec QRC stubby~
Love it! It's built very sturdy w/ thick plate steel and a nice finish, IMO about the best bang for the buck for a front stubby bumper. Those dinky fog light screws are a PITA to get in there though. I used some blue painters tape to keep the nut and washer together and then was able to get them both behind the bracket and thread the bolt in. After that it wasn't too bad, prior to that I was swearing like a drunken sailorHow you liking this so far? Mine will be here Wednesday.
Yes it’s a ROAM stubby bumperWhat bumper is that? Looks good!
Very tempted to take off my ARB stubby for the Hefty one. Such an awesome design.If I were to buy a stubby it would probably be the one from hefty fab works or expedition one.
Did you try to remove the quadratec logo?Love it! It's built very sturdy w/ thick plate steel and a nice finish, IMO about the best bang for the buck for a front stubby bumper. Those dinky fog light screws are a PITA to get in there though. I used some blue painters tape to keep the nut and washer together and then was able to get them both behind the bracket and thread the bolt in. After that it wasn't too bad, prior to that I was swearing like a drunken sailor
Look forward to your impressions.
I drilled into the upper plate to mount this light bar, and used the lower tabs for the pods, worked out well & was able to keep a low profile mount for better air flow through the radiator.
No, left it on, not really obtrusive.Did you try to remove the quadratec logo?
Question for you guys that run bumpers with the bull bars. How do they do in full service car washes with all the spinning brushes? I know real men wash they own Jeep by hand but some us like the full service wash from time to time.LOD Destroyer Stubby as well.