Motor Mount Replacement

[Res68]

Has anyone else blown a hydraulic motor mount? I have a 2020 2.0L and it blew up the drivers side mount a couple weeks ago, leaking hydraulic fluid everywhere and am having trouble finding a replacement.
Anybody have this happen and found a good replacement part? Any install notes or suggestions I might find handy?
Thanks

Sponsored

 

[luishasmail]

I think I just recently damaged one on mine. Not sure if it helps now since it's been so long but they seem to be in stock on mopar's website. I'm curious: was the fluid red and oily? I have a red and oily drip right under mine.

 

[mwilk012]

I think I just recently damaged one on mine. Not sure if it helps now since it's been so long but they seem to be in stock on mopar's website. I'm curious: was the fluid red and oily? I have a red and oily drip right under mine.

It’s usually very dark and kind of a strange texture, it dries quickly.

You could always just ignore it until the actual integrity of the mount is affected.

 

[J. Creeper]

Has anyone else blown a hydraulic motor mount? I have a 2020 2.0L and it blew up the drivers side mount a couple weeks ago, leaking hydraulic fluid everywhere and am having trouble finding a replacement.
Anybody have this happen and found a good replacement part? Any install notes or suggestions I might find handy?
Thanks

I know this is a very old post, but did you replace both of them? Is it only two Motor Mounts on the JL or 4?

 

[roaniecowpony]

68271527AC - Mopar Parts Giant

 

[Fast-n-Furious]

Had my wife's Audi A4 inspected today, both hydraulic motor mounts have leaked... And quoted me $1600 for the fix to pass inspection. Parts are $800 and labor $799. If it's the Jeep I may buy the parts and fix myself. Oh well... local shop don't have the tools to work on Audi.

 

[mwilk012]

Had my wife's Audi A4 inspected today, both hydraulic motor mounts have leaked... And quoted me $1600 for the fix to pass inspection. Parts are $800 and labor $799. If it's the Jeep I may buy the parts and fix myself. Oh well... local shop don't have the tools to work on Audi.

They think it takes special tools to work on an A4 engine mounts?

 

[Fast-n-Furious]

They think it takes special tools to work on an A4 engine mounts?

It's a very small local shop, I guess they either don't want take the job or don't know much about European cars.

I watched a video and it's not too hard actually.

 

[lettucetea42]

I know this is a very old post, but did you replace both of them? Is it only two Motor Mounts on the JL or 4?

I know this is an old comment but there are 2 motor mounts and 1 transmission mount, for a total of 3 mounts.

 

[J. Creeper]

Thank you.

 

[alston05]

What did you end up doing? I have a 2024 JL Willy's 3.6L that I bought and am rebuilding. Last night I discovered that the passenger side of the engine has become dislodged from its mount. I didn't know this prior because I have been so concerned with pulling the diamond out of the frame. Got the frame square and now the passenger side mount hole is about two inches in front of the bolt hole. I don't have any leaks in the mount at this point, but I'm hesitant to put any strain on the hydraulic part of the mount after reading this thread.

Sponsored