Mopar steering damper bracket

[Warz2k4]

Does anyone have this part sitting around after swapping their steering stabilizer and don’t need it?
I’m unable to remove mine to change my stabilizer.
Genuine Mopar Damper Bracket part#68309363AB
(For Dana 210 or Dana 186 without wide axles)

Sponsored

 

[BadA$$Rubi]

Cut and replace the bolt? ?

 

[Warz2k4]

Cut and replace the bolt? ?

cant cut the bolt head. It’s a carriage bolt. I believe that squared end is stuck.

 

[BadA$$Rubi]

You can cut the rounded head off with a cut off wheel, if you are careful about it. It should weaken the bolt enough to punch it out of the bracket. The shank most likely twisted in the bracket.

 

[BadA$$Rubi]

An extra pair of hands, a good bench vise, cut off wheel, drift punch, sledge and new bolt. You’ll get it!

 

[ArmannB]

I have one just installed a new stabilizer couple weeks ago. Its not in front of me but I have a rubicon, you sure these brackets are different for the wide axle?

 

[Warz2k4]

I have one just installed a new stabilizer couple weeks ago. Its not in front of me but I have a rubicon, you sure these brackets are different for the wide axle?

Do you have a 2Dr Rubicon? Those are wide axles.
The 4 Dr ones are the same part # that would fit my Sahara

 

[ArmannB]

Do you have a 2Dr Rubicon? Those are wide axles.
The 4 Dr ones are the same part # that would fit my Sahara

I have a 4 door

 

[Roky]

Probably quicker just to order one, bite the bullet

Sponsored