JSCAN Aux Switch Enablement

[Straightener]

I tried searching several different ways through the forum and didn’t come up with any results.

I know JSCAN can enable the factory AUX switches. I am getting ready to install the Mopar kit this week, and it has been a while since I used JSCAN. Does anyone know the proceedure? I would prefer to ask first rather than go in and fumble around with settings. I checked JSCAN’s site and it doesn’t appear they have a procedure written out for this either. Thanks in advance for any guidance!

Sponsored

 

[Terrymo]

I have factory aux switches but use JSCAN. A quick look at the app shows this.

 

[Straightener]

Awesome! I was hoping it was “obvious.” Thanks for sharing the screenshots - much appreciated.

 

[Terrymo]

Awesome! I was hoping it was “obvious.” Thanks for sharing the screenshots - much appreciated.

Good luck. I’m not a JSCAN expert but there are people on the forum that are

 

[Pismo61]

On the Jscan there are four categories on the Aux switch settings.Dose anyone know what to set all those at.Thanx I just added the switches.

 

[Pismo61]

On the Jscan there are four categories on the Aux switch settings.Dose anyone know what to set all those at.Thanx I just added the switches.

I Used the below J-Scan settings if anyone is interested.

Auxiliary Switch Bank Module Present On/Off = "Active"
Auxiliary Switches in CSM On/Off = "Switch 4 Option"
Auxiliary Switches On/Off = "Four"
Radio -> Auxiliary Switches On/Off = "Switch 4 option" This seemed to work.It was posted by eugeeezy.

Sponsored