StanleyCup99
Well-Known Member
Great stuff on that cup holder. Need that for my kids. MUST GET!!!
Sponsored
Got any pics of what size cup/bottle will fit in that cup holder? I didn’t see any dimensions listed on the Quadratec site of the individual cups, only the shipping dimensions.Mods completed. Sorry for the bad pics, it’s raining outside and I just washed it!
1) ACE rock sliders mounted to body mounts. (Easy install)
2) rear seat cup holders (two screws are very tricky to get out, but once completed looks factory and with 3 kids I need them!)
3) hitch (had to remove a plate on the steel bumper which was not clear in directions but was not too bad to get out with tie strap).
Same for mopar wrangler lock, incompatible.Bolt hood lock doesn’t work...kind of...the grill insert on the 4xe is different from the one that comes in the kit.
Can't think of any reason it wouldn't.Would a soft top from a 2019 still work?
Yes I have the Soft top from my 2018 JL on my 4xeWould a soft top from a 2019 still work?
Maybe for a short bit, but Im certain that the aftermarket will catch up fast. The 4XE appears to be a hot commodity and the aftermarket won't leave money on the table for long.Are we going to be out of luck on rear cargo mats because of that "lip" behind the rear seat/battery?
that lip lifts out place the mat and replace the lip on top of the matAre we going to be out of luck on rear cargo mats because of that "lip" behind the rear seat/battery?
What’s under the lip? Is it wiring? Can you post a pic of the lip removed?that lip lifts out place the mat and replace the lip on top of the mat
The rear seats on my son's Rubicon JKU fold flat so the seat backs are on the same level as the rear compartment. He is able to put an air mattress in there for camping etc. I presume a non-4xe JLU is the same or similar so the rear seats fold flat. (someone else will have to confirm this for me...)What’s under the lip? Is it wiring? Can you post a pic of the lip removed?
not a great pic this is with my slipstream installed right where that lip is. Again it lifts right out just cut the mat at the lip or a inch beyond. Personally I carry a Harbor Freight Packing blanket at all times, I do not need a matt tat is far more versitile for me.What’s under the lip? Is it wiring? Can you post a pic of the lip removed?
I just installed the 4 door ROAM rock sliders on the 4xe, but only 3 of the 4 frame brackets fit without issue. On the frame where the 3rd bracket sits, on the drivers side is a mounting bracket for the battery coolant lines that blocks the 3rd bracket, and on the passenger side another small plastic mounting tab for another battery line that blocks the 3rd bracket. You could easily detach the mounting clip for the battery lines on the driver side, and trim back the plastic bracket on the passenger side, but with how new these are I don't want to be the first guy to have warranty issues for something like that, so given I'm not bouncing off any rocks and am using them mostly as side steps, I just used 3 of the 4 frame brackets. ROAM does also have body mount brackets and those should work without any issues. I'm also going to email ROAM some pics I took. It would be pretty easy for them to modify the 3rd bracket to fit the 4xe.when will you be putting on the roam sliders? I ran them on 2 of my JLURs and was planning to order a new set for this one. but I am worried they won't fit if the fram is different as far as holes etc.