Laz
Well-Known Member
- First Name
- Tom
- Joined
- Jun 21, 2018
- Threads
- 27
- Messages
- 130
- Reaction score
- 20
- Location
- New Hampshire
- Vehicle(s)
- 2018 JLUS
- Thread starter
- #1
Hi all.
So had the Teraflex ST2 2-1/2 kit installed and my Jeep leans to the passenger side in both front and back. The driver side is about 1" higher in both front and back.
I purchased the front and rear 1/2" spacer kit and want to install on the passenger side only. My main question is can I drop just the passenger side of the axle and remove the springs to put the spacers in or will I need to remove both sides to get the passenger springs out?
My second question is these spacers look like they can be stacked to make up a full inch if needed. Should I just do the 1/2" in hopes that the shifting weight, if you will, will bring the driver side down 1/2"and level it out?
Any thoughts are appreciated.
Thanks
So had the Teraflex ST2 2-1/2 kit installed and my Jeep leans to the passenger side in both front and back. The driver side is about 1" higher in both front and back.
I purchased the front and rear 1/2" spacer kit and want to install on the passenger side only. My main question is can I drop just the passenger side of the axle and remove the springs to put the spacers in or will I need to remove both sides to get the passenger springs out?
My second question is these spacers look like they can be stacked to make up a full inch if needed. Should I just do the 1/2" in hopes that the shifting weight, if you will, will bring the driver side down 1/2"and level it out?
Any thoughts are appreciated.
Thanks
Sponsored