Icon wheels

[BamaJeep]

A couple of basic questions over the camera case and wheel fit. Do you recall what size hole saw you both used ? I was thinking a 2 5/8” or 3” but wasn’t sure. Also, when you say you sanded the camera housing down to fit do you mean with sand paper on a block or something powered?

Sponsored

 

[Focker]

A couple of basic questions over the camera case and wheel fit. Do you recall what size hole saw you both used ? I was thinking a 2 5/8” or 3” but wasn’t sure. Also, when you say you sanded the camera housing down to fit do you mean with sand paper on a block or something powered?

I don't recall the size I used. As far as sanding I used a block to keep it nice and flat.

 

[laniercruzer]

It was the same hole saw I used to put a dead bolt set in my door with, whatever that standard size is.

 

[BamaJeep]

It was the same hole saw I used to put a dead bolt set in my door with, whatever that standard size is.

Ahhh I see so I shouldn’t be too concerned about finding one specific to the final cut I am trying to achieve. Just get the hole cut and then use something else to trim to fit.

 

[wittyjeepusername]

I love my Icon Rebounds. Very glad I went with them.

@vrtraa this looks GREAT! I have a black Rubi too, and am debating between the Titanium or Satin Black Icon Rebounds. It looks like these are the Satin Black, right? If so, this is definitely what i am going with, looks STELLAR.

Sponsored