Sponsored

axle

  1. Metal machining debris in axle housing

    I changed the gear oil in the axles today in my '20 JLUR Recon with almost exactly 7K on the odometer. I wanted to change it now to get any break-in metal cleared out and then should be good for a while. The back one was a little dirty, but nothing special and went smoothly. The front, however...
  2. Stupid question.....? Could a JK D44 be swapped onto a JL?

    Just curious because I’ve seen several JL axle swaps onto a JK. Would be pretty neat and would open up some options if a JK axle could be swapped into a JL.
  3. New Mexico Dana 30/35 M186 M200 for sale

    I have a set of sport axles front and rear from my 2018 Sport. 3.45 gear. has less than 20000 miles on them. Axles while on Jeep only saw light off road, mostly dirt roads and pampered well. Very clean with no issues at all. Straight and solid axles. Brakes not includes, but you want to upgrade...
  4. Maryland WTB - Rubicon Take Off Axles

    Looking for both front and rear axles from a JLUR. Complete assembly would be preferred. (breaks, electronic sway bar, stock gears, etc.). Have truck and willing to travel pretty much anywhere east of the Mississippi. For the right price I could go further west.
  5. Crush sleeve eliminator for the Jl available?

    So im getting ready to setup 4.56 gears in my 2019 Jl sport, m186 front m220 rear. Im not the biggest fan of setting crush sleeves but for the life of me I can not find someone that sells elimniator kits for the new jl models. Anybody know of a supplier that I have not run across.
  6. California WTB Ultimate Dana 60 Rear Axle Complete

    Looking for an ultimate dana 60 rear axle complete with 5:38 gears and e locker.
  7. Axle seal leaking again, possible causes?

    So I had an axle seal leak (front passenger) back in April, and took the Jeep in to the dealership and they changed out a new seal. Only a month goes by and I found the same seal began leaking again. I know this is some crazy bad luck, but does anyone know if there are possible reasons behind...
  8. Need to Regear Your JL and live in the SoCal area?

    Need to Regear Your JL and live in the SoCal area? Get a new set of gears installed in BOTH axles for $1699.99, labor included! Details: $1699.99 installed (does not include tax) Price covers parts and labor Revolution Gear and Axle parts used Available for Dana 30/44 axles from 2018+...
  9. How much can I sell my axles for?

    I’m wondering how much I can sell my stock Sport axles for. I have D30 front and D44 rear with LSD.
  10. Upgrading to UD44 front 18 JLUS

    I have a 2018 JLUS with d30/d44 lsd. I am looking to upgrade the front axle to a UD44, which includes lockers and gears. I’m running 35s and want to go up to 37s eventually. My questions are, what gear ratio should I choose? Do I need to re gear the rear as well? Should I throw a locker on the...
  11. Gear Swapped to 4.88 via 4WP now rear locker light blinks

    So I just got my Jeep regeared yesterday and I have a slight issue. Whenever I start the Jeep the rear locker light blinks on the dash. Not like a service warning but like it’s engaging or disengaging when you normally press it. It isn’t though (its not locked), and the blinking goes away on its...
  12. Looking to regear your JL?

    Lift your Jeep? Bigger Tires? Worse gas mileage? Less power? Regear your Jeep! Half day install! Need to Regear Your JL and live in the SoCal area? Get a new set of gears installed in BOTH axles for $1699.99, labor included! Details: $1699.00 installed (does not include tax) Price covers...
  13. Installing 35s BFG

    Hi everyone, i am installing 35s tires with liftkit 2.5 .. jl sport 4 doors .. Should I upgrade the front axle ? Note that am using off-road and daily drive .. Thank you for your time .
  14. Rubicon axle swap?

    I have a 2018 Jeep Wrangler Sahara Unlimited (JL) with the D30/D35 front/rear axles I want to swap the stock axles for Rubicon D44 axles with E-Lockers. The Rubicon D44 on the JL is about 1.5" wider than the axles on my Sahara. Will the axles still bolt on directly without any fabrication...
  15. Rear axle "loose" and making noise

    So the other day it had rained and the roads still had a dampness to them. I decided to turn traction control off and punch it and did a little burn out. Did this twice. It was after this that I noticed the following... I was driving and let off the gas, then I got back on the gas, not hard...
  16. Submerging your axles

    My son-in-law has a JK Sahara and warned me that if I submerged my axles completely I should change my gear oil in case some water got in the breather tube. Yet on the rear gate of my JLU Sahara it shows a clear picture of the Jeep in water up to it's bumper saying you can go up to 30" deep...


Top