Jas0n
Well-Known Member
- Thread starter
- #1
Earlier tonight I turned on my Jeep and the tachometer was reading 2k with my foot pressed in on the clutch. The engine did not read below 2k no matter what I did. I turned it on and off a bunch of times. I’d watch the rpm needle do it’s initial check. It would start at 2k and go all the way past the 7k tic on the gauge. I couldn’t find any info online about this issue. Called Jeep and they said they haven’t heard of this issue yet. I decided to take off my negative terminal and let it sit for a minute. I put the terminal back on and it’s working normally now. Just thought I’d share this for anyone out there who might run into this issue. I’m hoping it doesn’t come back again. Appointment set up with the dealer tomorrow to have them double check everything!
Sponsored