OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #46
Yep, I need to do that.You need to update your build thread bro!
Sponsored
Sponsored
Rangemasters JL Diesel Build
- Thread starter Rangemaster
- Start date
- Watchers 7
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #48
yes, very great motor when off road.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #49
Here is a couple of pictures over the pass weekend, Took my son and his girl friend out for some pistol pratice.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #50
On black friday, I picked up a new GoPro 10 for my jeep to record my offroad trips.
I mounted it on my proclips dash mount. My iPad is mounted to the proclip mount with 2” wide velcro strips so its easy to remove and install real quick.
I mounted it on my proclips dash mount. My iPad is mounted to the proclip mount with 2” wide velcro strips so its easy to remove and install real quick.
Sponsored
19 JLUR Bright Whit3
Well-Known Member
I'm headed out to Moab at the end of April '23. PM me if you'd like to join.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #52
Here is a pick of my rockslide spare fuel containers. This was like a six month wait to get this setup over the summer.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #54
Here is a short video using my new GoPro, the only thing you can not tell how steep the hills are. But I do like how it takes the bumps and rolls smoothly.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #55
Yesterday, I finally broke into the front axle. Replacing the bad worn out ball joints at 5k miles, new RCV axles, Reed Knuckles and dynatrac ball joints. Here is a few pictures on the project.
If you plan on doing this on your jeep, get a good ball joint tool. I did mine with a Maddox tool. Had to modify the tool do to the slop of the axles where the ball joints mount.
If you plan on doing this on your jeep, get a good ball joint tool. I did mine with a Maddox tool. Had to modify the tool do to the slop of the axles where the ball joints mount.
Sponsored
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #56
Here is the finished product, I was able to button up the front end today and get a alignment. Got the Apex steering kit installed today.
OP
OP
Rangemaster
Well-Known Member
- Thread starter
- #57
I ordered a rear LED bar from Diode Dynamics, here is pictures of the install. Its fairly easy, the only tools you need are a 10mm socket, wire stripers, side cutters and crimper. I tied my light into the AUX switch that controls the low amp side of my ARB compressor which is mounted in the rear of my jeep. I think the total time of install maybe 2 hours at the most.
Sponsored
