Sponsored

Major Right Side Pulling

Slawder95

Member
First Name
Seth
Joined
Apr 20, 2025
Threads
3
Messages
9
Reaction score
5
Location
Katy, TX
Vehicle(s)
2019 Wrangler Sport Unlimited
Hello all, bought a 2019 Wrangler with 24k on it a month ago. So far I replaced all 4 tires with Cooper ATPs, all new rotors and pads, new front track bar, and steering stabilizer. Had alignment done after tires, track bar, and stabilizer. No death wobble but jeez does this thing pull extremely hard to the right, faster I go harder the pull. The steering wheel is also offset to the left for me to drive straight. Any idea what this could be? No accidents or frame damage.

Jeep Wrangler JL Major Right Side Pulling IMG_6181
Sponsored

 

RubenZ

Well-Known Member
First Name
Ruben
Joined
Jun 24, 2018
Threads
64
Messages
1,831
Reaction score
1,707
Location
Deep South Texas
Website
cyberrube.com
Vehicle(s)
2018 Silverado 2500HD Duramax, 18’ Toyota 4Runner
Is it stock? I would take it back to the alignment shop. If they redo it and then it still pulls the same, it could be their alignment equipment is off. Also, is the jeep stock?
 
OP
OP

Slawder95

Member
First Name
Seth
Joined
Apr 20, 2025
Threads
3
Messages
9
Reaction score
5
Location
Katy, TX
Vehicle(s)
2019 Wrangler Sport Unlimited
Is it stock? I would take it back to the alignment shop. If they redo it and then it still pulls the same, it could be their alignment equipment is off. Also, is the jeep stock?
Every thing stock besides what is mentioned above, the rear end is all stock with Mopar components, no lift.
 

Roky

Well-Known Member
First Name
Roky
Joined
Oct 4, 2018
Threads
45
Messages
10,699
Reaction score
29,217
Location
Florida
Vehicle(s)
2018 JLUR
Build Thread
Link
Every thing stock besides what is mentioned above, the rear end is all stock with Mopar components, no lift.
The thrust angle is off, likely from the front axle not centered with new adjustable track bar… since the rear control arms are stock and you said no accidents….the thrust angle being off will cause a pull…. Also you camber is out of spec, I’d make sure your ball joints are good, if so, you might look into some camber shims….Another thing is if you have a closed end steering stabilizer, they sometimes are pressurized, and can also cause a pull..
Sponsored

 
 







Top