ZgsProduct
Active Member
- Joined
- Mar 10, 2019
- Threads
- 7
- Messages
- 43
- Reaction score
- 25
- Location
- Pure Michigan
- Vehicle(s)
- 2018 JLUR 1987 YJ
- Thread starter
- #1
Good Morning,
I have a 2018 Rubicon that came with non-LED lighting from the factory. Over the time of ownership I have upgraded my taillights, headlights, & just recently my DRL to LEDs. Everything was plug & play, the taillights didn't need to get programmed from the dealer but the headlights did in order for the halos to work. A few days ago, I upgraded from halogen DRL to LED DRL. The first two days were fine until I noticed that when I try & use the right turn signal it give me a hyper flash. At first it was only the right side & today it happened to both. Usually they will correct themselves after I turn the Jeep off & start it back up & they will work properly with no hyper flash. Also, I do get an error on my dash saying the turn signals are out but like I said it's intermittent. The question I have is... Is this an electrical problem or do I simply need a bypass with a Tazer or a dealer code to be added in?
P.S. The actual DRL LED works fine, it's always on & doesn't give me any issues. It's just the turn signals!
If anyone else has an answer or has been through a similar situation please chime on in on your fix!
Thank you
I have a 2018 Rubicon that came with non-LED lighting from the factory. Over the time of ownership I have upgraded my taillights, headlights, & just recently my DRL to LEDs. Everything was plug & play, the taillights didn't need to get programmed from the dealer but the headlights did in order for the halos to work. A few days ago, I upgraded from halogen DRL to LED DRL. The first two days were fine until I noticed that when I try & use the right turn signal it give me a hyper flash. At first it was only the right side & today it happened to both. Usually they will correct themselves after I turn the Jeep off & start it back up & they will work properly with no hyper flash. Also, I do get an error on my dash saying the turn signals are out but like I said it's intermittent. The question I have is... Is this an electrical problem or do I simply need a bypass with a Tazer or a dealer code to be added in?
P.S. The actual DRL LED works fine, it's always on & doesn't give me any issues. It's just the turn signals!
If anyone else has an answer or has been through a similar situation please chime on in on your fix!
Thank you
Sponsored