GenRight Roll Cage Install

[chevymitchell]

Tubes tacked in place. Next is the windshield tube and some of the fwd and aft tubing.

Sponsored

 

[chevymitchell]

Windshield V-Bar installed and fwd/aft tubing for windshield cross bar to B-pillar cross bar. Video to follow.

 

[chevymitchell]

 

[chevymitchell]

Freedom top bracket tacked in place.

 

[chevymitchell]

Rear harness bar with X-bar.

 

[chevymitchell]

All tubes are installed!!

Was able to go from no tubes installed to a complete, tacked in cage in about 7 hours of work. This was doing it alone, as well.

If someone had help or the tubes were prepped before, you could have tubes tacked in place in 5 hours.

I still have a lot of work ahead though. Final welding and some things for the interior pieces still to do. It’ll have to wait until next weekend now, but I’m super excited about this. Very happy and impressed with this cage.

 

[1996cc]

Looks great! And the sideways video is way better, thanks!

 

[Ran4]

Shawn, this looks great. Top notch work, as per usual..

 

[chevymitchell]

Shawn, this looks great. Top notch work, as per usual..

Thanks Randy. Much appreciated!

 

[chevymitchell]

Had some good friends stop by and help take the cage out. Time to finish the welding portion.

 

[jhackathorne]

Had some good friends stop by and help take the cage out. Time to finish the welding portion.

Looks amazing. How easy/difficult was the removal?

I see lots of welding in your future!

 

[chevymitchell]

Looks amazing. How easy/difficult was the removal?

I see lots of welding in your future!

It wasn't bad once Scott noticed the correct angle of dangle to get the A-pillar pins out. Once that was lined up right, it came right out. I would suggest having at least 4 people. 5-6 to be the safest.

 

[chevymitchell]

Sorry for the video not being sideways... I forgot about doing that.

 

[chevymitchell]

Got the cage fully welded. The tubes, anyway. Still more little things to do tomorrow. I’ll snag another video once I get that set up. Hopefully put the cage back in the Jeep one more time, finalize everything and then remove for paint.

 

[1996cc]

How does that floor do with welding splatter? And what is it?

Sponsored