Globexradice
Well-Known Member
I have one more project I'm working on right now. As soon as that one is complete I can go back to this project.
Sponsored
Any update on a timeline for a compressor mount?I have one more project I'm working on right now. As soon as that one is complete I can go back to this project.
Picture?working on it. I just finished my last prototype rear tailgate bracket and next week i'm working on the dual setup.
Great news!Its tight under the hood but I did have it in there with room to spare.
34” before it gets wet... more than I’ll every do before water crossings.I ended up mounting my single ARB on top of the spare tire carrier, slightly tucked inside the spare wheel.
Just drilled holes and mounted it.
Did you make a single ARB hood mount though?Here is that last pic I have of it. My final one has a camera mount built in. Then off to laser for production.
Dual arb bracket may take a little work before its production ready. Its tight under the hood but I did have it in there with room to spare.
I did but it only was made to fit the small. So if you arent running one just for lockers it's not going to work. The large was just a little to big to fit on that bracketDid you make a single ARB hood mount though?
Where are you planning on putting the ARB twin?Here is that last pic I have of it. My final one has a camera mount built in. Then off to laser for production.
Dual arb bracket may take a little work before its production ready. Its tight under the hood but I did have it in there with room to spare.
I’ve got a mock up of an under the hood mounting bracket. Hope to have it ready for final fit next week. Will get some pics when I have it mounted.Where are you planning on putting the ARB twin?
How's this project going?I’ve got a mock up of an under the hood mounting bracket. Hope to have it ready for final fit next week. Will get some pics when I have it mounted.
You can check it out in the “Mounting ARB Air Compressor” thread. I am really happy with the results.How's this project going?
Ever get that dual compressor mount figured out?Here is that last pic I have of it. My final one has a camera mount built in. Then off to laser for production.
Dual arb bracket may take a little work before its production ready. Its tight under the hood but I did have it in there with room to spare.
Got it installed a couple months ago and it works great. I have had a few made for other forum members and so far the reports have been good. You can check it out at Goin2Drt build on this forumEver get that dual compressor mount figured out?