Hello. Looks great! What settings did you have to enable via jscan? I seem to have everything working, but my DRL stays on when the directional is enabled. I know that factory has the DRL disable while directional is in use. Thank youPicked up a set of painted fenders with factory LED DRL & Turn Signals(Got them working using JScan)
You need to activate drl dropout in jscan
I have a couple of the zauto locker harnesses if you want to go that route. Pulled from my previous Rubicon.Well, I broke it. Sort of!!
Rear diff lock is trying to engage/disengage when it should not be. Heading to the dealer to get it looked at today and will report what they tell me. I have seen a number of posts about the sensor and the fixes but still under warranty so i will try this route first.
Thank you!
Is this battery operated?i installed a couple of map lights I cant stand the light behind me casts shadows on where I need the light.
Azuto?i installed a couple of map lights I cant stand the light behind me casts shadows on where I need the light.
Very industrious. When you get done, drive by and help with mine. I only need everything. lolGot ambitious and started putting in my Apex rapid pressure valves (deflators).
https://www.apexdesignsusa.com/products/rapid-precision-valve
Used my hydraulic ram jack to break the beads.
Got two three installed but couldn't get a bead to seat on one and dropped the TPMS sensor into another.
I wrestled with one to get a bead to seat, tryin a ratchet strap and raising it up and standing on the rim, etc. No luck. Got dark and I packed up for the night. Tomorrow is starter fluid seating.
I bought a set from @AllMoparParts.com in 2019 for my 2018. The look is so good. The only issue I have is the gauge cluster hyper-flashes and shows they are out, but the outside blinks correctly. If I understand they put in two different light harnesses in 2018 for halogen and LED. After that they put in thePicked up a set of painted fenders with factory LED DRL & Turn Signals(Got them working using JScan)
Same for the TazerJL mini
Sadie, our Border Colli, helped with the install. She.s a good helper. I should have taken a picture.next time.I installed the rear OEM Tan Leather seats from a 2018 Sahara take-off and the Mopar Gap Hider, Rear Seat & Cargo Area Mats.
The only thing that didn’t go as planned or smoothly was I cross threaded one seat bolt. The bolt that is closest to the driver’s passenger door on the slant back. I thought I had it started but that wasn’t the case.
Did you disable light out monitoring for left & right turn signal? Did yoy change light settings to LED in BCM?
I put a set of OEM LED front DRL/turns on my 2018. All that was required was to toggle the option in JSCAN. The harness is not specific to either LED or Halogen.
