Recursion
Well-Known Member
- Thread starter
- #1
I posted about this elsewhere, but thought this deserved its own thread. I just installed this rack system (from RaiderRack.com) on the inside of my JLUR tailgate. This system includes a horizontal rack (similar to the TRMS rail) and up to 7 vertical mini racks that snap-fit into the lower louvers. Each rack has two t-slots, which provides some spacing flexibility when arranging mounting accessories. They also have some mounting accessories available, including just the t-slot hardware if you want to mount your own stuff (which I also did). I bought several pieces & some hardware, and grabbed some additional accessories online (cup holders & quick-fist clamps off amazon). That "indentation" on the top of the gate is a party-foul waiting to happen!
These racks are very solid, and the fit & finish are perfect. For the top rack, I popped off the tailgate's horizontal plastic cover and bolted the rack into the factory holes (There were some included spacers.) The vertical racks just snapped-in: insert the top at an angle, rotate the rack flat against the louvers, then push to snap it in. I couldn't remove them by hand, I needed a putty knife to pop them off from the bottom.
I'm very impressed. I'm still figuring out how to arrange everything, but I'm getting close.
These racks are very solid, and the fit & finish are perfect. For the top rack, I popped off the tailgate's horizontal plastic cover and bolted the rack into the factory holes (There were some included spacers.) The vertical racks just snapped-in: insert the top at an angle, rotate the rack flat against the louvers, then push to snap it in. I couldn't remove them by hand, I needed a putty knife to pop them off from the bottom.
I'm very impressed. I'm still figuring out how to arrange everything, but I'm getting close.
Sponsored