flanders
Well-Known Member
- Thread starter
- #1
I know this is a long shot, but here goes...
I've been chasing a vibrating noise for months. Torn apart most of the dash trying to find it. It only happens for 10-15 minutes after starting the jeep cold. Once the coolant warms up, rattling gone.
I've followed the noise to the coolant lines going into the heater core behind the glove box.
If I pull on the bottom line, sometimes the rattling is dampened a little? It's a sharp rattle like metal on metal.
I've pulled out the actuators and some other stuff trying to get a better look at these lines, but I think I've gone as far as I can.
Does anyone have any experience with this? As far as I can tell the lines aren't touching each other or anything else, but I can't see the full length.
Any help would be super appreciated.
I've been chasing a vibrating noise for months. Torn apart most of the dash trying to find it. It only happens for 10-15 minutes after starting the jeep cold. Once the coolant warms up, rattling gone.
I've followed the noise to the coolant lines going into the heater core behind the glove box.
If I pull on the bottom line, sometimes the rattling is dampened a little? It's a sharp rattle like metal on metal.
I've pulled out the actuators and some other stuff trying to get a better look at these lines, but I think I've gone as far as I can.
Does anyone have any experience with this? As far as I can tell the lines aren't touching each other or anything else, but I can't see the full length.
Any help would be super appreciated.
Sponsored