TMD78
Well-Known Member
I believe the most current is 82215416ADDo you happen to have the part number handy?
Sponsored
I believe the most current is 82215416ADDo you happen to have the part number handy?
Thank you!I believe the most current is 82215416AD
This is the table I’m going with soon. Like the hinge design (ala AAL) and the cutting board (ala Outback). Don’t want cable hinges and I want a sliding cutting board for extra space. I learned a long time ago, you get what you pay for. This table seems to fit the bill for me!Goose Gear is as previously said, solid, well built and noise free going down the rode. Like that it doesn't have cables or braces on the sides.![]()
![]()
When I've called them on the phone they have answered every time and were very knowledgeable on their products. Great quality products and good people to work with.
I don‘t mind paying for quantity and design, but those logos (especially the two when open) are a deal-breaker for me. I haven’t decided on a table yet but know I like the tables with an extendable board.3 Logos. 2 open and 1 closed
I grew up in the '60s and pretty much followed Winwood all along his path...Across all of the various forums I've been on, you are the first person to ever get that! I'm impressed! It is a great song, and Traffic is such an under appreciated band.
see my post...easy to install...the holes are already drilled and tapped in the tailgate under the black plastic cover...there are two holes in the plastic cover at the top that are ready to be drilled out...Hooke-Road supplies a template that worked fine in marking the third hole at the bottom of the plastic cover...all three holes lined up easily and I was able to set the table on a jack and screw it to the tailgate without help.Anyone have any experience or luck getting one of these on a JL(U)?
https://www.amazon.com/Hooke-Road-Wrangler-Compatible-Unlimited/dp/B09PDR8GYH/.
Love the deeper second shelf for grill or stove, but not sure about the mounting...
How’s it look closed?
The big holes where the tabs are cut from and then bent out appear to leave plenty of space for air molecules to flow. I would highly doubt that panel, bolted directly to the door, seals anything. Just sayin'.Gregs Customer pre-sale Service went non-existent when i asked about blocking the air vents; there was one weak failed attempt to justify that there was still "enough" venting and no responses after my comparing the amount of original venting area compared to what was left after the install of the table. pity, because it's pretty stuff.
i spend too much time in too many different environments (from humid coastal to Mojave and Sonora Dez dry) to consider using anything that compromises the Environmental controls.