Another Oracle light error question...

[cmb396]

Just installed flush mount taillights on JLUR, oem leds, lights work as they should, but getting hyperflash and "turn signals out" dash warning.
Can someone point me in the right direction with Tazer menus and what settings to change to fix this? Appreciate it!

Sponsored

 

[observer]

Not sure this is what your asking for but it's as close as i could find if i understand your question.
Hope this helps.

 

[cmb396]

Not sure this is what your asking for but it's as close as i could find if i understand your question.
Hope this helps.

Yes, thank you. Just didn't know where to go in the menu. That said, got a pm from another member that said this does not work and Jscan has to be used. So idk?!

 

[observer]

Yeah I hear you. Idk either. As said new to the game but wonder if those who had no luck bothered to do this reboot process correctly. here's someone else who kind of mentions the having to do this reboot thing.

best of luck.

 

[cmb396]

Yeah I hear you. Idk either. As said new to the game but wonder if those who had no luck bothered to do this reboot process correctly. here's someone else who kind of mentions the having to do this reboot thing.

best of luck.

Thanks again for the vid. I'll give it a shot and report back.

 

[ORACLElights]

Please take a moment to fill out our online tech support request here: https://www.oraclelights.com/pages/tech-support-form and someone from our technical department will be in contact with you shortly. You can also reach us directly at [email protected]. Thank you!

 

[ScotM]

I remember some folks having issues when the factory was a led tail light. I think the answer was to set them to halogen with JScan, let the jeep go to sleep then change them to LED. Mine were factory halogen and no issues going the LEDs with the oracle lights

 

[cmb396]

I remember some folks having issues when the factory was a led tail light. I think the answer was to set them to halogen with JScan, let the jeep go to sleep then change them to LED. Mine were factory halogen and no issues going the LEDs with the oracle lights

Essentially what I have to do with the tazer. The latest update addresses this. Need to update my tazer, turn led to off, cycle 3x, turn back to led on, cycle another 3x, should fix it.

Sponsored