AAL Tailgate Table Installed

[jellis4148]

So, I just install the American Adventure Labs Tailgate table. Install is pretty easy. Definitely would be easier with extra set of hands. The main reason for the post is about the wiring. I'm not a fan of T-clips, or any kind of splicing if it can be avoided. Yes, you can solder, and probably never have an issue. Anyway, I was searching and found this on Amazon. By far the best way. to wire in the light, and it came with a fuse. On a side note, the tailgate table is awesome. Yes they are a little pricey, but well worth it in m opinion. Here is a pic and a link to what I used.



https://www.amazon.com/dp/B0886DNNSP?psc=1&ref=ppx_yo2ov_dt_b_product_details

Sponsored

 

[aggiechris]

Where does that connector tie in?
I also loved the aal table. My only complaint was the wires were very thin gauge.

 

[jellis4148]

12 volt outlet on the drivers side rear panel.

 

[Roky]

No pics ??

 

[jellis4148]

No pics ??

Here you go.

Sponsored