Florida 3D printed switch panel

[loydd24]

Would you only need this piece sent? If so I would be willing to take mine out and send to you.

Yes that’s it, I actually have someone shipping me one tomorrow. Once I have a design made for it I’ll post it here

Sponsored

 

[Goin2drt]

Wow nice work. Looks complete factory. You are talented.

 

[loydd24]

Wow nice work. Looks complete factory. You are talented.

Thank you!

 

[WranglerMan]

@Genesis Offroad needs to contact you as this would be a good place to mount there G screen, it looks very nice and Job well done Sir

 

[loydd24]

@Genesis Offroad needs to contact you as this would be a good place to mount there G screen, it looks very nice and Job well done Sir

I appreciate it and If the demand was there I’d definitely get something made up that integrates it!

 

[loydd24]

Would you only need this piece sent? If so I would be willing to take mine out and send to you.

So the guy who was going to send me one ended up throwing it away on accident. If you want to send me yours I’ll make a panel and send it back with your cubby. PM me if you’re interested

 

[funglenn]

Yes I can as long as the half cubby is a perfect half of the full size cubby. The holes will have to be drilled into the switch panel if you choose to bolt it in because I don’t have access to a half size cubby to make a design. It’s a perfect fit on the full size and technically doesn’t need to be bolted, I added the bolts for peace of mind.

any pictures of the half panel option for Rubicon? i only need 3-4 switches. how much painted with switches? can you do rocker switches?

 

[loydd24]

any pictures of the half panel option for Rubicon? i only need 3-4 switches. how much painted with switches? can you do rocker switches?

I should have the cubby tomorrow to design it and I should have it designed by Friday. I could do rocker switches but I think I’d only be able to squeeze 3 of them on there.

 

[loydd24]

Can you make one for the Rubi that has the half-size cubby?

Here’s one for the half cubby

 

[loydd24]

Any chance a 3 over 2 stacked / staggered button layout could work? I really like these but only have the empty cubby on the bottom right where the OEM aux switches would go. Locker switch panel on the left side.

This is what I came up with, I can only fit 4 or 5 if I use 12mm switches(these are 16mm)

 

[SlowPoke21]

Nice work dude.

 

[loydd24]

Nice work dude.

Thank you

 

[loydd24]

Here’s one that was requested from another member. Has a 12v plug in the center and 4 switches.

 

[loydd24]

Updated original post for those interested in a panel that doesn’t require any cutting/holes for the full cubby and half cubby.

 

[sgtmajor138]

Updated original post for those interested in a panel that doesn’t require any cutting/holes for the full cubby and half cubby.

Just to clarify (I am a little slow at times, so please bare with me), do you make one that fits a 2020 Wrangler Sport S with 5 red switches unpainted? I looked on your Etsy site but did not see that specific option.
Also, You mentioned earlier in this thread that you have a "no drill" option. Do you use 2-way tape to secure the plate to the cubby?
Thanks in advance. BTW, excellent work! I wish I was as talented and insightful as a lot of you guys on this site.

Sponsored