2021 JLUR Cup Holder Coaster Inserts?

[ynygma]

Heya all,

Sadly, the car wash lost my inserts for my Jeep - they are still looking but my guess is they are gone

I am unable to find the OEM part for this because I would like to replace them. Does anyone know where I can find these, not Amazon or eBay knockoffs, please?

Sponsored

 

[Jeepeto]

Dealership parts counter?

 

[ynygma]

Dealership parts counter?

Was hoping to find them online, but I will prolly have to call the dealer...

 

[Ct_Formula]

Also check Etsy.com

 

[Jeepeto]

Was hoping to find them online, but I will prolly have to call the dealer...

https://www.moparpartswebstore.com/...75663966__7543327/Floor-Console/i2375277.html

Is this what you’re looking for. I’m not entirely sure what you mean by inserts

 

[ynygma]

I mean these:

 

[Ct_Formula]

These are soapstone and absorb condensation

 

[Rhinebeck01]

@ynygma

A couple of years ago there was a Forum Sponsor (no longer here) selling cup holder inserts..... Those inserts and some other such Chinese offerings sold on Amazon and eBAY.... were melting and damaging the cup holders.. and flying up out of the cup as they were so thin....

With that said... be very very careful what you buy/install, insert wise.. especially if you live in warm climate locales..

For quality Dual foam ...Durable, Non-Absorbent, Non-Skid, Noise Reduced ... cup holder inserts... Made in USA / hot hot, Florida ...that is know to be very good and not melt or easily fly out of the holder consider this offering..

They have tape to secure but not needed....

https://www.tufskinz.com/products/interior-foam-jeep-wrangler-jl?_pos=1&_sid=e3d9a527f&_ss=r

 

[Rhinebeck01]

I mean these:

That's one of the Chinese crapola offerings I mentioned... Surprised they did not melt or fly away before the car wash vacuumed them up...

 

[Bryce]

I mean these:

You won't find an OEM part number for these becase ther are not OEM.

 

[Rhinebeck01]

You won't find an OEM part number for these becase ther are not OEM.

The JL/JLU/JT do not leave the factory with an "insert" of any kind in any cupholder(s).

 

[Sidspider]

Wouldn’t an insert block the little light in there?

 

[Jeepeto]

Wouldn’t an insert block the little light in there?

Sidspider is asking the real questions here.

I really like that little light too ?

 

[Rhinebeck01]

Wouldn’t an insert block the little light in there?

@Sidspider
@Jeepeto

I have the Tufskinz inserts that I linked to earlier in this thread... they are dual foam and quite thicker then the Chinese crapola ones... Fit is very good and ... yes, they do block a slight slight bit of the LED light output in the front cup holder but not enough that it matters... or enough that most would be at all concerned about..

 

[ynygma]

The JL/JLU/JT do not leave the factory with an "insert" of any kind in any cupholder(s).

My buddy's JT came with them stock when he bought it off the lot.

Sponsored