Tailgate Table

[MiKiEPNyC]

Installed the Mopar Tailgate Table today... Relatively easy install. Hardest part was finding a 13mm drill bit. Had to drill 4 holes but they were clearly marked on the backside of the trim panel.

https://www.allmoparparts.com/sku/82215416ab.html

Sponsored

 

[JaytheJeepGuy]

That looks really good. How do the cup holders work?

 

[MiKiEPNyC]

That looks really good. How do the cup holders work?

Perfect for Red Solo cups... Not going to work for bottles without some other mod...

 

[JDP]

Would this work with the trail rail kit?

 

[MiKiEPNyC]

Yes I believe it does. Came with two sets of instructions, one with the rail and one if you don’t have it.

 

[jlroman2]

But can you sit on it? :D

 

[Lurvis33]

Perfect for Red Solo cups... Not going to work for bottles without some other mod...

Does it hold something like a 30 oz Yeti/RTIC cup?

 

[PaulNY]

Reminds me of this :cwl:

 

[RisingEagle]

Perfect for Red Solo cups... Not going to work for bottles without some other mod...

I'm no fabricator by any stretch of the imagination, but I would wager you could drill a couple holes on the sides of the cup-holes, thread a "bended" piece of metal (coat hanger cut-out) through it, and it would 'flop' down to support a bottle / monster can / etc. bending the lips that go through the metal up would let it flop half-way. Think I've seen something like that before someplace

sorry my description stinks - but I can see where you could rig something up. alternatively - you could rivet a piece of 550-paracord with about 3 inches of slack and it would do the same thing

I am planning to get one of these when my jeep arrives, but may have to look at aftermarket. I know with the JKs they had some with a small cutting board section, etc.

nice work on the install; appreciate the photos

 

[ArmyCrawler]

Please after market, make mesh inserts for the cup holders like in camping chairs...

 

[citzen z]

But can you sit on it? :D

I think they only hold about 30 lbs or so.

 

[Finally a Wrangler]

25lbs according to the website.

 

[MiKiEPNyC]

25lbs according to the website.

Yes 25 lbs. there’s a warning label on the table

 

[MiKiEPNyC]

Does it hold something like a 30 oz Yeti/RTIC cup?

I would think so. I’ll try out my Yeti and Tervis and see if they fit.

 

[GRAK]

Installed the Mopar Tailgate Table today... Relatively easy install. Hardest part was finding a 13mm drill bit. Had to drill 4 holes but they were clearly marked on the backside of the trim panel.

https://www.allmoparparts.com/sku/82215416ab.html

i remember seeing a cutting board addition for the jk table.. would be extra comfy if avail for jl

Sponsored