Sway Disconnect Question

[GavinH]

I have a Rubicon so electronic disconnect but I’m about to install JKS quick discos. Will I see more flex with the discos fully disconnected via the quick disconnect or will it be negligible compared to the electronic factory disco? Not sure if cutting and all that’s worth it, I have a Tazer so away kill is awesome but curious specifically about flexing. Thanks

Sponsored

 

[chadk77]

Probably more flex with the discos disconnected depending on how much droop you have.

I have the Metalcloak disconnects and you don't have to cut anything.

 

[GavinH]

Probably more flex with the discos disconnected depending on how much droop you have.

I have the Metalcloak disconnects and you don't have to cut anything.

I like the concept on those how it comes with the extra bracket and the pin pre installed. Luckily it’s a super easy swap so I’ll probably keep my JKS for now using the electronic disco and sell these off and buy the MC. Do those have zerk fittings on them the JKS do and I don’t really understand why

 

[chadk77]

No zerk on mine. The MC discos are pretty cheap too.

 

[GavinH]

No zerk on mine. The MC discos are pretty cheap too.

All positives I can see, do you remember what length you set them at? I appreciate the replies.

 

[chadk77]

All positives I can see, do you remember what length you set them at? I appreciate the replies.

I honestly do not. I originally had the links that came with my MC GC 3.5” lift which were bolted on but NOT quick disconnects so I just measured the angle of the sway bar then set it back to that angle. I can measure them this evening though.

 

[GavinH]

I honestly do not. I originally had the links that came with my MC GC 3.5” lift which were bolted on but NOT quick disconnects so I just measured the angle of the sway bar then set it back to that angle. I can measure them this evening though.

Cool thank you I’m only doing a 1.5-2 inch lift but I was still curious what a taller lift would have them at

Sponsored