Rough Country Multiple Light Controller? HELP!

[chance79]

So I have a JL and recently got a Rough Country Multiple Light Controller thinking I’d be able to hook up ALL OF MY LIGHTS (besides stock headlights etc); I’m having trouble wiring up my light bars and under glow. The upper LED light bar is an Auxbeam and the underglow is Street Glo. Is there a way to hook these products up to the Rough Country Controller? I can’t find ANY videos of anyone hooking up any type of light bar light to the brain of the RC. I did, however, ended up cutting the black, red, and wiring harness and plugged it directly into the brain. It worked but not sure if it’s a good idea. Is it obvious that I can’t/ shouldn’t hook up the light bar and neons? New to all of this. TIA!

Sponsored

 

[lalalofsky]

what do the connections on the lights look like? On the engine side of the panel are the hookups.

 

[chance79]

This is for the LED upper light bar.

 

[chance79]

And this is the brain where all of the lights and other products should be able to be directly hooked up.

 

[lalalofsky]

OKay cool, so if I’m not mistaken each of the screws on the left there are for the power and ground. In the red circle indicated the switch, and in the black is the ground. Take the red eyelet and screw it down onto the switch number that you want it at and take the black eyelet and screw it down on the ground next to it.

 

[lalalofsky]

That being said, if the Eyelets do not fit you might need to cut them off and cut back some of the wire insulation and put that wire under the metal clamp that the screw is on. I dont know how it works to setup, but that would do it. Its one of those options for sure.

 

[lalalofsky]

Did you get it put together?

 

[chance79]

YES! I think we managed to figure it all out. Thank you so much for your help.

 

[JLTruman]

You got it, too bad I didn't see this earlier I could have helped and posted pics

Sponsored