Jeff2018
Well-Known Member
- First Name
- Jeff
- Joined
- Sep 10, 2018
- Threads
- 30
- Messages
- 161
- Reaction score
- 75
- Location
- Indianapolis
- Vehicle(s)
- 2021 JL Rubicon Unlimited EcoDiesel
- Thread starter
- #1
Hi Everyone,
I have searched the forum and haven't found an answer to a question I have about the proper sequence for reinstalling all of the trim at the door openings (side and bottom). I recently finished the wiring for the Rockslide steps and I am putting things back together now.
It's not too difficult to figure our some of the trim pieces. The problem is when everything goes together there are a couple joints that don't seem like good fits. I'd like to avoid just beating and banging on the trim with my hands or a rubber mallet. My primary concern is to not pinch any wires.
Is there a sequence/procedure that anyone has found for doing this?
Thanks,
Jeff
I have searched the forum and haven't found an answer to a question I have about the proper sequence for reinstalling all of the trim at the door openings (side and bottom). I recently finished the wiring for the Rockslide steps and I am putting things back together now.
It's not too difficult to figure our some of the trim pieces. The problem is when everything goes together there are a couple joints that don't seem like good fits. I'd like to avoid just beating and banging on the trim with my hands or a rubber mallet. My primary concern is to not pinch any wires.
Is there a sequence/procedure that anyone has found for doing this?
Thanks,
Jeff
Sponsored