The Last Cowboy
Well-Known Member
- First Name
- Joe
- Joined
- Jul 2, 2020
- Threads
- 35
- Messages
- 7,471
- Reaction score
- 14,753
- Location
- San Antonio, TX
- Vehicle(s)
- 2020 JL Willys 2 door
- Occupation
- Straight shooter with a crooked grin
- Thread starter
- #1
I had an issue a couple of weeks ago when went to the beach. When I went to use 4Hi, the front axle didn't engage. There were no lights of any kind on the dash, not even the SERV 4WD light.
I wound up browsing the Tazer Mini menu and found the the front axle was somehow disabled. I took care of that, and now it goes into 4WD when I pull the lever. But there is no indicator light on the dash.
I haven't messed with the Tazer for months, since my tail light and front turn signal install. 4WD worked in July, which was the last time I used it.
I'm thinking this may be Tazer related, but not sure where to look in the menu. My next step will be to unmarry the Tazer, then update it. I just hate the hassle of the scrolling through the menu, then the sleep cycles again.
Thoughts anyone.
I wound up browsing the Tazer Mini menu and found the the front axle was somehow disabled. I took care of that, and now it goes into 4WD when I pull the lever. But there is no indicator light on the dash.
I haven't messed with the Tazer for months, since my tail light and front turn signal install. 4WD worked in July, which was the last time I used it.
I'm thinking this may be Tazer related, but not sure where to look in the menu. My next step will be to unmarry the Tazer, then update it. I just hate the hassle of the scrolling through the menu, then the sleep cycles again.
Thoughts anyone.
Sponsored
