Ravager
Well-Known Member
- Thread starter
- #1
More pics as I go but here is my quandry: The bumper doesn't fit. I DON'T think this is a MB issue. The craftsmanship on this bumper is off the charts in a good way. In addition, I already powder coated it so I don't want there to be an issue with it
But here is the real data, the bumper rests just a smidge too high and the bolts won't fit. I noticed a gap and sure enough it appears the sloppy weld is the cause; the blop is high enough to keep the bumper from being flush. You can see daylight in the first pic.
The second pic is a better-welded bumper.
Do I:
1) Grind down the weld
2) Enlarge the holes (recommended only to 5/8")
3) Modify the bumper so it fits around the weld
4) Sell you the bumper (not gonna happen)
But here is the real data, the bumper rests just a smidge too high and the bolts won't fit. I noticed a gap and sure enough it appears the sloppy weld is the cause; the blop is high enough to keep the bumper from being flush. You can see daylight in the first pic.
The second pic is a better-welded bumper.
Do I:
1) Grind down the weld
2) Enlarge the holes (recommended only to 5/8")
3) Modify the bumper so it fits around the weld
4) Sell you the bumper (not gonna happen)
Sponsored