2024 accessory gauges gone, except for voltage?

[IdowaJeeper]

I was scrolling through my menu and wanted to check on the engine temp and all I have is the voltmeter..

It's a pretty intuitive screen and I messed around with it for a bit and couldn't figure it out. Tried reset, tried shutting off the vehicle and restarting. Nothing so far.

Any ideas?

Sponsored

 

[Fatfreewilly]

Other than holding the power button down until it does a soft reset... I got nothing.

I'd check with the dealer.

 

[Ratbert]

I was scrolling through my menu and wanted to check on the engine temp and all I have is the voltmeter..

It's a pretty intuitive screen and I messed around with it for a bit and couldn't figure it out. Tried reset, tried shutting off the vehicle and restarting. Nothing so far.

Any ideas?

Did it return to normal today?

 

[IdowaJeeper]

Did it return to normal today?

Nope. I tried resetting it and returning to factory settings. Nothing.

All I've done was install the winch and disconnect a ground wire on the battery momentarily while the winch ground was added.

Not sure how to restart the Uconnect 5 system to see if that helps. EDIT: looked it up and will go try that.

 

[Dlit]

It has been stated on the forum that it can take a few days after a reset or software update. Park it where it has a good signal an hope big brother does its thing…….good luck.

 

[IdowaJeeper]

The restart worked! Back to normal and no dealer visit needed. Nice!

Sponsored