anotheraznguy
Well-Known Member
- Joined
- Jul 30, 2018
- Threads
- 44
- Messages
- 672
- Reaction score
- 996
- Location
- Tracy California
- Vehicle(s)
- Mojito JLUR
- Vehicle Showcase
- 1
The trigger system has an optional mount for the JL. Honestly I'm not to impressed with the mount, switches, or back lighting.
They responded to an email I sent and said because of the design and ability to run wireless on two watch style batteries the LED's have to be made to draw as little power as possible. I chose to hard wire it into my mirror so that I could have the always on Rocker back lights, but I almost wish I didn't as from the angle you sit it makes it difficult to see if an accessory is on/off on certain switches.
The mount separated on me when installing it because it is held together by two tiny screws. Fortunately I was able to tighten them up, but still have a minor gap that I don't like. In all the pictures I've seen online that switch mount is a 1 piece design which would have eliminated that issue.
The rockers themselves require a good bit of force to depress. In any normal bolt on installation this would be fine, but because the factory plastic header is only held on by clips rather than any bolts it moves a good bit when toggling those switches.
Here is a crappy picture I just took. I will do a full review on it when I've spent more time with it.
![]()
Can't wait to hear your review. I was doing some research and in the past with a previous version it appeared that there were connection issues.,
Sponsored

