Threaded bolt hole

[JLBanjo]

Does anyone know the bolt size for the tapped frame holes you see when looking under the jeep?

Sponsored

 

[Terrymo]

Does anyone know the bolt size for the tapped frame holes you see when looking under the jeep?

For the highest odds of a correct answer, post a pic of what you’re asking about. Otherwise be ready for a lot of speculation and wild ass guesses.

 

[plex]

they are metrics, so can be anywhere between M12 and M18.

 

[Terrymo]

@JLBanjo
I believe M12-1.5 I’ll check later today.
This is a very worthwhile investment
https://www.amazon.com/CKE-Bolt-Thr...keywords=Thread+Checker&qid=1713965927&sr=8-1

 

[ParadigmDawg]

Doesn't the LOD rock rails use the hole? I bet their website will lead you to an answer.

 

[Terrymo]

@JLBanjo
Confirmed M12-1.5. The length provided by Metalcloak for their skids is 45mm but uses a thick conical washer. 40-45mm length should get you in the ballpark depending on what you’re using it for.

 

[JLBanjo]

Thanks!!

Does anyone know the bolt size for the tapped frame holes you see when looking under the jeep?

 

[OrneryBear]

I would think those are likely there for the assembly line moving the frame/jeep around.

 

[ParadigmDawg]

I would think those are likely there for the assembly line moving the frame/jeep around.

You know, if a Jeeper sees a hole, he is going to put something in it....

 

[OrneryBear]

You know, if a Jeeper sees a hole, he is going to put something in it....

it's true, can't lie it's nice they are there for mounting stuff aftermarket.

 

[Terrymo]

You know, if a Jeeper sees a hole, he is going to put something in it....

Sponsored