Fox Stabilizer & Metalcloak

[ResqFE]

Is anyone using a Fox Steering stabilizer and the Metalcloak relocation bracket set up? Issues or concerns? Any pics. Thanks

Sponsored

 

[Friday2322]

Is anyone using a Fox Steering stabilizer and the Metalcloak relocation bracket set up? Issues or concerns? Any pics. Thanks

I was having issues with the Rocksport and bumpsteer. MC called me the same day after I emailed them and said they pulled the HD steering kit with the Rocksport off the website to address valving issues and said it would be a couple of months before they started selling it again. They recommended going back to the stock steering stabilizer or a Fox one. I still had my stock one so I put it back on and haven't had any issues since. They said they had heard that people were having good luck with the Fox stabilizer working with the new JL steering.

 

[ResqFE]

I seem to not have the full steer anymore with Rocksport.... have opportunity to get a Fox Stabilizer from a buddy.

 

[Djhyper66]

I have metal cloak tie rod and drag links with fox steering…. Everything looks good so far.. turn the wheel all the way left and right and life is good so far !! Handle super good.. install the sector shaft brace at the same time.. can drive the car with one hand most of the time .

 

[Fast-n-Furious]

I have metal cloak tie rod and drag links with fox steering…. Everything looks good so far.. turn the wheel all the way left and right and life is good so far !! Handle super good.. install the sector shaft brace at the same time.. can drive the car with one hand most of the time .

Are you still liking this stabilizer relocation setup?

 

[Djhyper66]

Are you still liking this stabilizer relocation setup?

Had jeep for 4 year .. now .. everything still drive decent ..

 

[Fast-n-Furious]

Had jeep for 4 year .. now .. everything still drive decent ..

Thanks! I’ll get the MetalCloak stabilizer relocation bracket for the Fox ATS. Been trying to figure this out and tried a different bracket first but causing clamp to diff cover rubbing. This MetalCloak bracket should do the trick.

 

[jiwooncc]

Just bought this whole set up. I noticed the bracket is mounted up for the steering stabilizer. Do you think using the Synergy long stud would work? The one that goes through the front track bar and using alan key to tighten up the screw.

I noticed the angle that metalcloak creates is higher and more angled and not parallel to the tie rod. Not sure if that will be an issue down the road.

Sponsored