gearhead22
Active Member
- Thread starter
- #1
I replaced the ball joints on my JT a week ago. I didn’t think much of it until now as I’m chasing down a shake/wobble while driving.
I noticed with the new ball joints installed, and just the knuckle connected to the ball joints (no axle shaft, wheel bearing etc), the knuckle has no resistance when moving side to side. It just rotates side to side effortlessly. Is this normal? Should there be resistance when rotating it side to side?
I noticed with the new ball joints installed, and just the knuckle connected to the ball joints (no axle shaft, wheel bearing etc), the knuckle has no resistance when moving side to side. It just rotates side to side effortlessly. Is this normal? Should there be resistance when rotating it side to side?
Sponsored
