Door sill gaurd PPF

[R 3]

Here is the rough prototype of the front sill gaurd I out lined it in black sharpe to help distinguish.
I would like to hear some thoughts on the coverage and if more or less is wanted befor I put them into final production tomarrow
Thanks
Matt,

Sponsored

 

[FatBoy01]

@R 3

Coverage looks adequate to me.

 

[R 3]

Here is the rear prototype

 

[jdpatt12]

Will it be visible when the doors are closed?
Looks good so far.

 

[R 3]

You might be able to see it if your with in a few feet and looking for it. My guys at the shop knew I was test fitting a new part and it took them a wile to figure out what I put on,

 

[$uicide$hift]

For those wanting that full coverage it is fine. I think it is more than necessary however. That may just be me.

I was going to call a few local places to see what they would charge to do this very thing. What I personally would like to have done:

A shape that starts from the top edge where the interior plastic is like you have. Not as wide as our feet won't go that far back. I also would not want it to go to the outside body as you have. The reason for this is I was thinking of asking for a carbon fiber vinyl instead of clear. Lastly what I think would look great is if there is a way to have Jeep or Wrangler in clear with the carbon fiber around it.

So a die cut of "Jeep" or "Wrangler" and then have a clear piece under or over the carbon fiber vinyl.

OK I'll put down the crack pipe!

 

[R 3]

Here are the revised sill protectors that offer more protection and are less noticable than befor

 

[jdpatt12]

Is this a 3m clear protection?

 

[R 3]

Yes it is
This is 3m scotch gaurd pro.

 

[jdpatt12]

How wide of a film did you use?

 

[R 3]

All the parts I produce are cut off a 60" wide roll

 

[R 3]

Door sill guards are now on the web site
Www.r3offroad.com

 

[Young04]

Door sill guards are now on the web site
Www.r3offroad.com

Will you be doing something for the rear fenders? I have a JLUR on order and want to order everything (door hinges, sills and fenders) together.

 

[R 3]

Yes we are I'm am focusing on the rear fenders now.
I'm cutting prototypes tonite and if I'm close I will post pics.

 

[R 3]

Just a update I had a slight delay on rear fender cover but I am working to make it avalible asap!!

Sponsored