Combo/Drive Light Recommendation

[Headbarcode]

Hey Mike where did you tap in for the running light /DLR lead hookup?

Are you referring to the amber backlights for the LP4's? If so, I tapped them into the running light circuit of the Jeep. I didn't want to risk overloading just one side, even though they draw very little, so I tapped 2 into each of the front fender harnesses. The harness plug is behind the top of the fender liners, towards the rear of the wheelwell. I used a test light to confirm which of the 4 wires was the running lights, so I don't know the wire color off hand.

Sponsored

 

[Ct_Formula]

Cool thanks Mike, I’m wiring in mine this weekend and didn’t want to miss any hidden wiring I could use.
She looks great man, I can’t imagine how bright they are in person.
Thanks again

What mounts are you using for the Apillar and ditch lights?

 

[Headbarcode]

Cool thanks Mike, I’m wiring in mine this weekend and didn’t want to miss any hidden wiring I could use.
She looks great man, I can’t imagine how bright they are in person.
Thanks again

What mounts are you using for the Apillar and ditch lights?

Shit, I'm just seeing this now. Apologies for the delayed response! I have the Go Rhino cowl mount. I didn't use the u-shaped brackets that came with it because the Squadron Pros already had them. Plus, theirs are meant for larger pods. They should offer it without those brackets at a lower price. I just really liked the staggered layout and it's a very solid mount.

 

[Ct_Formula]

Shit, I'm just seeing this now. Apologies for the delayed response! I have the Go Rhino cowl mount. I didn't use the u-shaped brackets that came with it because the Squadron Pros already had them. Plus, theirs are meant for larger pods. They should offer it without those brackets at a lower price. I just really liked the staggered layout and it's a very solid mount.

I'm running the Diode Dynamics 4" on the center spot, then the SS2Pros for fog ditch lights. The SS4 pros were a little view blocking so I made some modifications and made a new bracket piece to extend them out farther and then powder coated them. They don't vibrate or shake or have wind noise so in my book its all a winner!

 

[Headbarcode]

I'm running the Diode Dynamics 4" on the center spot, then the SS2Pros for fog ditch lights. The SS4 pros were a little view blocking so I made some modifications and made a new bracket piece to extend them out farther and then powder coated them. They don't vibrate or shake or have wind noise so in my book its all a winner!

The Squadron Pros are 3"x3" and just barely hide behind the registration and inspection stickers and the passenger side ones barely even blip my peripheral radar. Mine are setup the same as yours, as far as a forward facing spot and a wide cornering turned out and downward for ditch/flank lighting.

Good job with the bracket modification!

 

[Ct_Formula]

Thanks man, I'm going to get creative now that I can powder coat steel and make some custom mounts for some BD for the front bumper

Sponsored