Auxiliary Switches

[Trauma PA]

Can these be added on by myself or dealer or are they only a factory option.
If so, anyone have the part number?
Thanks in advance.

Sponsored

 

[Kenny]

Can these be added on by myself or dealer or are they only a factory option.
If so, anyone have the part number?
Thanks in advance.

A lot of folks here have added. https://www.allmoparparts.com/sku-y...MIouaphJPz4gIVEv5kCh3y1Q54EAQYAyABEgLPuPD_BwE

 

[lightsout]

They are expensive though, worth maybe $75, Mopar wants $270 (should be $270 installed), I just added my own for $10 ea (I have added a 3rd one since this pic)

 

[rustyshakelford]

You can install them but I believe they need to be activated by the dealer or a tazer so they will be recognized

Brett

 

[WillDo559]

Integrates with uconnect, has options to be a button or switch, fits in the location made for it, not too bad of an install. But yeah you will need a programmer to enable it or have the dealership flash. Or you can cut holes in your trim panel for $10

 

[onesight1]

What if you got ahold of JUST the switch? would you be able to somehow use a generic/standard harness (lets say from some KC lights lamps you have installed to switch) to connect to the OEM AUX without all the fancy bs to the uconnect?

I just want OEM looking switches for my lights/winch, etc

 

[vavaroutsos]

What if you got ahold of JUST the switch? would you be able to somehow use a generic/standard harness (lets say from some KC lights lamps you have installed to switch) to connect to the OEM AUX without all the fancy bs to the uconnect?

I just want OEM looking switches for my lights/winch, etc

No, they are not power switches. They are part of a module that is on the CAN bus. The switches are momentary contact for signalling to the controller in the switch module which then communicates to the relay module installed in the engine compartment.

Sponsored