2024 Willys Order

[mjf4241]

Yes, it's part of the 22W (Willys) Package and it appears on both the Build Sheet and the Window Sticker. Here's a picture of that portion of our window sticker:

That's so cool. I had a 2018 JLUR Rubicon and this Willys is so close to it. I think only thing this doesn't have that it did is the front Tru-Lok axle and sway bar disconnects.

Sponsored

 

[FLAirgunner]

That's so cool. I had a 2018 JLUR Rubicon and this Willys is so close to it. I think only thing this doesn't have that it did is the front Tru-Lok axle and sway bar disconnects.

And it's about $5K to $10K less depending upon options! Living in Florida, I didn't really think it would need the front locker or sway bar disconnects, so this was really the perfect package for us!

 

[KevinBoston]

@KevinBoston and @FLAirgunner wondering if your window sticker says 4.10 ratio gears or 3.45 ratio gears. Reason I ask is because the order sheets were updated 7/13/2023 and Willys package shows 4.10 gears included. Just wondering if your Jeeps have 4.10 gears with the Willys package.

4.10 Rear Axle Ratio. One of the reasons I wanted a Willys with 33' tires.
Window sticker with Willys package attached

 

[yoitsmeg19XX]

I ordered a 24 Willys 2 door in Anvil and 6-speed.
EP: $38,747
FFP: $40,245

I recently added the Convenience Package

 

[mjf4241]

Guess i will join in on the wait. Ordered Friday July 28th. Got Vin next day.

2024 Willys Anvil, 2.0, Xtreme, Safety, Convenience, Headliner, Hardtop

I see you're from the same area of Texas. You on upper or lower Gulf Coast? I'm north of Houston. Glad to meet ya.

 

[RAD1]

I went to order a Willys 2 door. They had one very similar to the one I was ordering in transit. Picked it up yesterday. 2 Door Anvil.

Congrats! Nice to see someone local get a '24 Willys in Anvil. Did good 'ol Herb give you anything off MSRP? I've got a 4 Dr Willys Anvil V6 6MT on order - fingers crossed I get it before the snow flies.

 

[KevinBoston]

Congrats! Nice to see someone local get a '24 Willys in Anvil. Did good 'ol Herb give you anything off MSRP? I've got a 4 Dr Willys Anvil V6 6MT on order - fingers crossed I get it before the snow flies.

They did not move on the MSRP, but I think I got good price $9,000 for my trade: 2007 4 Door Sahara I purchased new 16 years ago

 

[ScottTex]

I see you're from the same area of Texas. You on upper or lower Gulf Coast? I'm north of Houston. Glad to meet ya.

I'm in Houston as well, but have a house on west beach in galveston, so hit the sand over in Surfside pretty often. Plus annual PINS trips in the fall when its not 100 degrees.

 

[GolfR]

Took Willy out for some photos today. Removed the Freedom Panals and installed the Spiderweb Shade...

Which sun shade did you go with? I haven’t been able to find one that looks like it will work with the side airbags.

 

[FLAirgunner]

Which sun shade did you go with? I haven’t been able to find one that looks like it will work with the side airbags.

The Spiderweb Shade, the cords go over the top and attach to the screws on the lower outside of the roll cage, so it doesn’t interfere with the side curtain air bags.

 

[GolfR]

The Spiderweb Shade, the cords go over the top and attach to the screws on the lower outside of the roll cage, so it doesn’t interfere with the side curtain air bags.

Thanks for the suggestion. It does look like these will work. Did the round bungee holders not work where the screws go in? From the install videos on YouTube it looks like the recessed area at the screws may be smaller than the older models?

Did you get the half cover or the full?

 

[FLAirgunner]

Thanks for the suggestion. It does look like these will work. Did the round bungee holders not work where the screws go in? From the install videos on YouTube it looks like the recessed area at the screws may be smaller than the older models?

Did you get the half cover or the full?

I got the half cover, I think the call it the JLkini. The nubs (small round silver things) don’t work on the 2024. They are aware of this and are re-engineering them for the 2024. The tolerances on the trim is too tight and Jeep used larger washers on the trim screws. I contacted Spiderweb Shield and they suggested installing it this way until the have the new nubs. I was told they would send me a set once they have them.

 

[GolfR]

I got the half cover, I think the call it the JLkini. The nubs (small round silver things) don’t work on the 2024. They are aware of this and are re-engineering them for the 2024. The tolerances on the trim is too tight and Jeep used larger washers on the trim screws. I contacted Spiderweb Shield and they suggested installing it this way until the have the new nubs. I was told they would send me a set once they have them.

Good to know. Is it hard to get the freedom panels latched and unlatched with the shade in?

 

[FLAirgunner]

Good to know. Is it hard to get the freedom panels latched and unlatched with the shade in?

It’s more challenging with the shade attached, but not really difficult. It’s more having to reach under the shade to grab the handles, but the shade flex’s enough to do it.
I just wish Jeep made the rear side windows so the opened to increase air flow through the cabin!

 

[GolfR]

It’s more challenging with the shade attached, but not really difficult. It’s more having to reach under the shade to grab the handles, but the shade flex’s enough to do it.
I just wish Jeep made the rear side windows so the opened to increase air flow through the cabin!

Lots of discussion in other threads about driving with the rear window open. Doesn’t seem to be a problem, although it is a bit odd looking.

I do love the small back window in my F150. The window seems kind of worthless until you open the sunroof and the back window and get a very nice non-buffeting breeze at highway speeds.

I’m actually wondering if I didn’t make a mistake getting the hardtop. I already bought a soft top and I wondering if I will ever even use the hardtop.

Sponsored