I've got about 7k miles on my 2022 Wrangler Rubicon Xtreme Recon. Today I did a 5-tire rotation.
After pulling off each of my rear tires, I noticed that the wheel hub had a decent amount of surface rust. By contrast, the front hubs were fairly clean.
So two questions: Is this normal? And...
Simple question here but just want to be safe.
Last year when I changed my engine oil for the first time in my 3.6L eTorque JL, I added 5 quarts just like the manual says. However, in the days afterward I noticed that when I checked the dipstick, the oil level was probably 1/8" or more above...
Hey guys, need some help with my new GMRS setup.
This weekend I installed the 15w Midland MXT275 install following fairly closely to an install by a fellow Jeeper over on the 392 forums (see here). I've got the base unit mounted behind the passenger kick panel (a little tricky, admittedly)...
Need some quick help for this weekend's project, guys.
I have various accessories running in the back of my JLUR, and I want to plan ahead for future accessories I might install (e.g. rear camera) which require the use of an ignition signal. I already have an ignition signal wire that I ran to...
Hey guys, need some help to interpret the results I'm seeing with my new Battery Tender and the factory 700-amp AGM starter battery included in the HD electrical group for my 3.6L eTorque.
I recently bought the 4-bank, 1.25a Battery Tender to keep my starter battery, my auxiliary battery in the...
Hey guys, just going through my first routine maintenance job this week on my JLUR and need some input.
The manual states that twice a year, I should supposedly lubricate the door hinge joints with grease. So I got to browsing online and now I've stumbled into the big wide aftermarket of door...
Hey guys, just did my first 5-tire rotation on the Jeep last night and had a couple questions.
First, I bought some jack stands with the idea of doing the approach a lot of guys talk about for tire rotations, where the Jeep is put on four stands and all the tires are rotated at once. However...
Hi guys,
I am trying to figure out where to route & mount an Anderson plug on the rear of my Jeep for solar power and need some help.
I have the American Adventure Labs setup in my rear floor cubby (air compressor, REDARC BCDC1225 charger, and auxiliary battery). My initial plan of attack was...
Hey guys. So I've been reading up on ideal tire pressures for the last few days and trying to settle on what's "best" (a loaded term, I know) for my 2022 JLUR XR with 35" tires (BF Goodrich KO2 LT315/70R17 113 load range C).
The door placard calls for 37 PSI for all four tires. I was running...
So I have a 2022 JLUR with the Xtreme Recon package. I'm looking to get some added storage capacity on the Jeep for things like jerry cans or traction boards, but I'm not quite sure yet whether I want a roof rack. As a result, I'm now thinking about how I can make use of the spare tire.
A few...
This upcoming weekend, I need to run a 6 AWG power wire from my main battery (2022 Wrangler automatic with eTorque) to the rear in-floor cubby to power my REDARC & auxiliary battery setup.
I know people generally tackle getting cable to the back of the Jeep in one of two ways: (1) running the...
Hi guys,
I'm gearing up to likely install a REDARC DCDC charger plus an auxiliary battery in my 2022 eTorque Wrangler to support my accessory power needs while camping.
The REDARC charger includes a blue input trigger wire that is ordinarily connected to the vehicle's ignition wire in cases...
I’m hoping you guys can clear up some confusion I have about the eTorque 3.6.
I’m still waiting on my 2022 Rubicon to show up, but when I ordered it I got it with the Xtreme Recon package. As a result, I had no choice but to accept the 3.6 eTorque engine. OK, fine by me.
However, I also...