Search results

I have a 2022 JLUR (sarge green) that has some corrosion issues. It has 55K miles on it with the 5 year warranty expiring in Jan. '27. A Jeep dealer in NH has been good to work with and advised that Jeep has agreed to replace my entire hood and do corrective paint work on all of the door...

I posted about this in the past and it's happening again intermittently. Probably because we're dealing with cold weather now in New Hampshire. When I start the Jeep , the battery voltage reads around 13.0-13.2, and then quickly climbs up to around 14.5. I get the error message that the aux...

Popped the hood recently and started hearing a tick which I hadn't noticed before. Is this normal for the 3.6 eTorque? It gets regular care, oil changes, etc. Basically trying to figure out if this is the lifter or similar issue and if I need to get it to a dealer ASAP before the warranty...

I’ve never noticed this before, but when a text message comes in, and the jeep announces who the text messages from, my AC shut off temporarily. It’s like it is adjusting for sound so that it can read the text. What the hell? Anyone else had this issue and fixed it?

I listed these locally in NH as well. Four tires for sale, all with even wear. Rotated every 3000 miles. 32,000 miles on them. D Load measuring 37x12.5x17R. New tire (spare) that I am keeping has new tread measuring 15/32. All four of the tires being sold have 9/32 of tread left (per calipers...

I was going to list these locally in NH but don't know what I should do for a value. Four tires for sale, all with even wear. Rotated every 3000 miles. 32,000 miles on them. D Load measuring 37x12.5x17R. New tire (spare) that I am keeping has new tread measuring 15/32. All four of the tires...

I just got this message when I turned on my jeep. It’s a 2022 Rubicon XR. It’s the same factory battery, now with 37,000 miles on it. V6 eTorque motor. I left my iPad plugged into the charger for about three hours while I was inside. Did that caused the issue? Or do I have something else going...

Anyone have new 37" KO2 D Load Range tires in the New England area?

I just had a MetalCloak Tie Rod out on my '22 Rubi. I am running fully built ProRock44 as well. Prior to the MetalCloak, I had a Rusty's tie rod and had no issues (same axle) running a Fox 2.0 TS (pass through) stabilizer. However, my mechanic said it wouldn't fit with the MetalCloak Tie rod...

I have a ProRock44 with RCV shafts and 4.56 gears that has about 20K miles on it. It’s a daily driver so most of the mileage is on road. 37” BFG K02s. Axle is 18 months old, outside of the warranty, so Dynatrac basically told me to pound sand. I have a whine coming from the front axle tied...

Does anyone else’s dealer make them sign paperwork regarding a diagnostic fee? I brought my JLUR XR ‘22 in this morning to look at the Wheel Hub Assembly because my regular mechanic thinks a bearing may have gone bad. I get a “whirring” noise when I drive. 33K miles on the Jeep, Dynatrac...

Build is a 2022 JLU Rubicon XR, 3.5” MetalCloak Game Changer (w. Rocksports), and 37” BFG K02s. It is weighed down by full belly steel skids, and steel front/rear bumpers. It has a ProRock 44 fully built front axle with 4.56 gearing (RCV shafts, Dynatrac rebuildable ball joints, etc.). It has...

Local pickup in Southern NH or will ship for an extra $25. Brand new. Box was opened, but parts were never pulled out of their protection plastic. Never swapped off my MetalCloak skid. Part #ROSRS62117

Hi guys, in cold weather my steering has been locking up especially on left hand turns. It's especially cold right now in Concord, New Hampshire and I just experienced it locking up in both directions. This happens after I run the auto start for 15 minutes so the engine should be warm. It scared...

I have a 2022 JLUR XR with about 9000 miles on it. Shut my driver’s front door today and heard this weird rattle. So I shut it a few more times and was able to get it to repeat. Popped the drain plug off and the spring fell out! Everything seems to work on the door, all latches and handles, and...

I have about 4000 miles on a MetalCloak 3.5” Gamechanger full kit with Rocksport shocks and their front drive shaft. Crawling under the Jeep I noticed that I have what appears to be a rub mark on the drive shaft. My only guess is that it is hitting the cross member that attaches to the factory...

I have a buddy who might buy a JLU Rubicon front axle to replace his front axle and is wondering if he the 32 spline outer shafts on his Dana 30 plus his u joint will work with the Dana 44 Rubicon axle shafts. I can’t recall if the Dana 30 U joint is a 1310 or a 1350. Anybody know the answer?

FOUND

Does anyone have the axle shaft dimensions for the ProRock44? I am trying to find some alternative chromoly shafts to put in mine and RCV/Dynatracs shafts and back ordered. I called Yukon and they need the dimensions to confirm if they have any in stock. I am going to keep the RCV shafts I...

I have had a ProRock44 on order from Dynatrac since mid-March and caught up with them yesterday. They told me that the hold up is with the RCV axle shafts and that they have customers who ordered in February and still haven’t received them yet for their build. They couldn’t give me an ETA, but...