Stinger Heigh10 install

[Nukem]

2018 Jeep Wrangler Rubicon. Looking for ideas on how best to get all the wires pushed into place to mount the radio. I can get the top screws in, but the bottom won't push in far enough. Though about cutting the extra wires, but Stinger advises me not too. Made several attempts and getting severely frustrated at this point.

Sponsored

 

[Flip]

I have an idea of what you're going through. Sometimes on stereo installs I would roll up the excess wire and use a small ziptie to tighten it up, tuck them in areas where it looks like there might be a little more room.

Best of luck buddy.

 

[rworld1]

I've done this install twice now on both my wranglers and redone once after adding a camera. you kinda have to divide the wiring into 4 areas bottom left and right and top left and right put what you can above and below the ducts. make sure you keep wires to their respective sides. I pushed my XM receiver way down by the canbus. and even then it was really tight but I gently pulled it in with the screws. I havnt had any issues with either aside from a needed firmware update on one to gain environmental controls.

Sponsored