stevieb92
Well-Known Member
- First Name
- Steve
- Joined
- Jun 5, 2020
- Threads
- 66
- Messages
- 311
- Reaction score
- 455
- Location
- Pittsburgh, PA
- Vehicle(s)
- 2020 JLU Rubicon 2.0t
- Occupation
- Mechanical Engineer
- Thread starter
- #1
Hey all. This past summer I purchased the Rugged Ridge Locking Hood Catch Kit and installed them on my Jeep. Finally got around to putting a video together covering a quick unboxing, the install and a short review of them. In short, I like them for the most part and they do a good job of keeping the underhood area secure. One thing I didn't care for is that in a certain position, the latch would lay against the fender of my Rubicon. There is a feature where it will hold itself up off the fender, but if you're not aware, it could lay down on the fender. In my case, my fenders are painted, so I didn't care for that too much. I suspect that someone with the low fenders of a non-Rubicon wouldn't have this issue, but I can't confirm that. If you interested, check out my video. Thanks!
Sponsored