Module location : Park Assist?

[lohr500]

Hi all, does anyone have a map which shows the physical location of each of the control modules?
In particular, I am keen to find where the parksense module is located.
I have a problem with the front Park Sense (discussed in a separate post).

Having studied the wiring diagram for the parking system, I can see that the front and back sensors are both fed from Fuse 33 and that the Park Sense module is connected via the can bus to the wider system.

So I have concluded that I may have a poor connection block somewhere in the wiring to the front sensors, or the system has not been configured/enabled correctly when built. If I can locate the module, I can make sure the harness plug is correctly seated, and check the other harness connections shown on the diagram.

It may save me a trip to the dealers and a lot of time sitting around if I can trace the fault myself!

Thanks.

Sponsored

 

[lohr500]

Update.

I think I've found where it is hidden. The "ENTIRE_VEHICLE-CONNECTOR_MAP.pdf file in the wiring diagram sticky shows the module as being somewhere at the rear right of the vehicle close to the rear tail lamp cluster.

I suspect I will need to be removing the trim in that area shortly to wire up a trailer harness anyway, so depending on my fault finding at the front of the vehicle tomorrow, I will search it out.

 

[Swagger]

Did you ever find the location of the park sense module? I have a problem where the sensors quit working when hot out (rear sensors for me). Think it may be a ground or module issue, but need to find it to diagnose.

Really weird, service message comes on and off while driving. Blind spot and rear camera unaffected.

 

[RideMyWillys]

So I installed the Proximity locks on my 2021 Willys Unlimited and after buying the Tazer Mini, I was able to configure the computer to operate the Proximity Locks. They work as if they came from factory thanks to the kit i purchased from Mopar.com. My next project is making the Rubicon rear bumper I bought used, work with my vehicle. I’m installing this bumper because I found it used with the sensors and harness. The problem I’m having is that I can’t find where the Park Sensor Module is located.
Does anyone know where the module is located on a Sport? It’s different than where the Rubicon and Sahara modules are located. HELP! ANYONE? ?

 

[EU_Wrangler]

Did you ever find the location of the park sense module? I have a problem where the sensors quit working when hot out (rear sensors for me). Think it may be a ground or module issue, but need to find it to diagnose.

Really weird, service message comes on and off while driving. Blind spot and rear camera unaffected.

Sponsored