fad

Working through a front axle rebuild and ended up with a bit of a hybrid setup. Looking for some input from anyone familiar with the M210/FAD internals. Base vehicle is a 2024 Willys with a damaged front axle housing and missing intermediate shaft. For the rebuild, I picked up a 2018 JL Rubicon...

Recently had 2025 Rubicon axles w/ no FAD installed on my 2018 Sport. Used a Tazer to try and eliminate the Serv 4WD light from with no success. Also tried with JScan, but according to some others the FAD has to be disabled while still plugged in, which isn’t an option now. Is there a dummy plug...

We've got overstock on Genuine Dana-Spicer Advantek Chromoly NO-FAD front axle shaft kit. So the boss says let's get them on SALE! SAE 4340 nickel chromoly axle shafts Nickle chromoly gives added toughness and strength Ultrasonically tested for defects Includes FAD removal kit ***These are for...

Hi all! Could anybody give a suggestion for the below story, please? I have my FAD failed after being few hours stuck in water. I decided to get rid of that system. I have installed Dana spicer FAD removal kit on my Rubicon 2021 JLUR 2.0L Then I deactivated FAD by JScan. But I don't have 4WD...

Used Rockhard4x4 FAD skid. $80 OBO - Located in Chantilly VA

Hello Gents, Yesterday I took my JLUR 2018 3.6 MT for a regular service which included oil change, tire rotation, cabin filter replacement and the multi-point inspection. After I picked up my vehicle I noticed a weird metal to metal grinding noise coming from the front driver side to what...

I have a front and rear set of stock axles from a 2020 sport s, about 15k miles. Just finishing the swap, upgraded to a set of crate axles so I can run 37’s. I haven’t off-roaded, no known damage, tab for Synergy sway bar disconnects pre-cut, drive shifts included, knuckles included, FAD on...

Anyone know how to remove the front Intermediate Axle shaft bearing ? The one that can be seen at the FAD. Mine has exploded and left the outer raceway still inside the axle tube.... I've tried getting a flathead/pry bar in there with no luck.

Sooooo.... I am replacing my front springs with Rubi springs, but I cannot get the dang harness off. The top has a grey clip, which I pulled out about 1/8th inch or so, which clearly clicks. Still the harness won't budge. So what is the trick. I am bowing my head in shame :( . As you can see...

sold

So my transfer case grenaded (inout shaft bearing failed) in my 18 JLUR at 24000 miles and, at the same time, I thought the service manager said that the locker fork that actuated the sleeve in the front differential had broke too. I took it at face value thinking it was just a freak event. 4000...